Now open putty and Click on the Serial radio button and enter text into text box “/dev/ttyusb0” as shown in the below image.
#Coolterm send data xbee install
Linux user can simply install putty using terminal in Linux (debian versions)įor other distribution download the source file and go to the directory using terminal and type following commandsġ. Reset the settings incase if it is sleeping mode.
#Coolterm send data xbee update
Try to update firmware which may solve if it is not working due to do some previous settings.Reconnect your module and check if it is properly connected.Check settings like baud rate settings.If you get problem in connecting XBee with your computer then: Now you can type other commands to see the parameters, Type ATSH and hit enter and you can see as shown below the higher address 32 bit address which is static address assigned by digi.If not then wait for more than 10 seconds and retype +++ to renter command Type +++ (don't press enter) if you get OK as a response appear then proceed.For that click on Terminal as shown below in the image and check Local Echo and then click on OK.Ĭlick on Connect button as shown in the image below, after clicking To see what you are writing properly in terminal you will need additional enable the Local Echo. After Clicking on options a new window will open, Scan for ports using button “ReScan Serial Ports” once you get the COM port set the: Now open the CoolTerm Applications by clicking on its icon and then go to Connection menu -> Opitons. There are variety of terminal applications are available for various platforms to communicate with XBee, for simplicity we will use CoolTerm as it is compatible with Windows and MAC, the software is free and available for all the OSes like MAC, Windows, Linux.ĭrag the CoolTermMac folder from Downloads folder to Applications folder and CoolTerm icon will appear on the Launchpad automatically. Alternatively now you can use XCTU for the same.Ĭonnecting XBee module to Computer for communication: This directory would be very useful while communicating XBee with python.įor windows go Control Panel-> device manager-> Look for Com ports in the devices as shown below in case you are using putty or using python. Ls/dev/tty (mac users must enter ls/dev/tty.*)Īs shown in image above you will see /dev/ttyUSB0, ensure that you have not connected other USB devices in that case the USB1, 2 or x. You will see something like FTDI USB serial Device converter now connected to or cp210x in this case attached to “ ttyUSB0” After opening terminal you need to use the following command lines to see if your device is properly recognized by your system or not. Additionally while connected to more than one module we can see you have to be a bit more careful. You can detect your XBee radio module in Linux and Mac OSX, by opening a Terminal, you can type a few commands to see if the module is recognized by your computer.
In the end, we will be able to send text from one computer to another like a Chatting application.ĭetecting attached XBee module in Computer: In this tutorial we will interface two XBee modules with two Computers and make the computers communicate wirelessly using those XBee modules. In previous tutorial we have learned about ZigBee protocol, its architecture and also learned about XBee modules and AT Commands.
0 kommentar(er)
